Mistakes in Installation of Solar LED Street Light
Solar led street light has been widely implemented, and it is an excellent light in terms of energy-saving, low carbon, and environmental protection. At the same time, due to solar power generation, the project cost will be relatively reduced. Some users will use solar LED street lights for some time. They reflected that the solar LED street light did not illuminate after installation, or could only illuminate for a few hours.The main reason for this situation is that the construction personnel do not know enough about the installation requirements of solar LED street light, and the installation of solar LED street light is inappropriate, which leads to the failure of normal charging of the solar panel, which leads to the ineffectiveness or unlighting of solar LED street light. What are the misconceptions about installing solar LED street light?First of all, there are no obstacles to the installation position of solar LED street light. Once the barrier blocks the light, it will easily affect the absorption and utilization of solar energy. Solar panels will not charge directly or reluctantly.Secondly, the installation of solar LED street light is too dense, or solar LED street light is installed next to other street lights, and the other street light is on, causing the solar street light panel to detect the light source, mistakenly believing that the sun is shining, causing the voltage of the rechargeable solar panel to take effect, and the light will not naturally light up.Third, the shadow on the solar panel cannot directly receive the solar light source because the solar panel is usually a string of cells. Even if the string of cells is used in the shadow, it cannot work normally. The string of lights is broken, so the charging efficiency of the solar panel is very low or it may not be able to charge.Finally, double-arm solar LED street light, double-arm solar LED street light should be connected to the solar power supply of the two light caps. If both solar panels are connected to a power source and installed obliquely face to face, only one side of the solar panel can be ensured to be effective. On the other hand, since the light source cannot directly impact the solar panel, the charging efficiency is reduced.
中文简体